Canon Camera Basic Guide Flash metering
Metering for ambient lighting conditions and flash metering has totally different requirement. The metering for ambient lighting condition is done before the shutter of the camera is opened. In the Canon EOS camera, ambient light metering is done when you press the shutter button halfway down. Flash Pulse metering however is done when the shutter button is press fully down. There are two ways to meter for flash pulse automatically. One way is by measuring the flash pulse as it is being released. The other way is to do a pre-flash test. This is achieved by a low powered test pulse of a calculated brightness before the shutter opens.
These are the two methods of flash metering which Canon uses for their system. The first method as described above is the Through The Lens (TTL) system. This method was first introduced by Canon during the 1980s with the introduction of the T90 model. The system was later adopted by the EOS range of Cameras as a standard feature. This makes the T90 as the only non EOS Camera which uses the TTL flash metering system.
The TTL system works by calculating the amount of light which is reflected off the subject into the camera after the flash light is emitted by the flash unit. It actually measures the light which is reflected of the film in real time and this done by using an OTF (Off The Film) sensor. When enough light has entered the OTF sensor, the flash will be deactivated. Due to the fact that the Canon EOS Digital cameras do not use films, the Digital range of Canon cameras does not support the TTL system.
The TTL metering system works in the following manner and order:
1. Once the shutter button is depress midway, the metering for ambient lighting takes places. The speed of the shutter and size of the aperture is programmed by the camera or User depending on which program mode the camera is using. For example whether the camera is using the AV, P or M mode.
2. Only when the shutter button is depressed all the way, the internal mirror is turn up and exposes the film. Power is then sent to the flash unit which will emit a flash light to illuminate the scene. The length of the flash pulse is determined by the OTF sensor in the camera which is metered for normal operational conditions. If the picture is taken under bright lighting conditions, the auto fill reduction will take effect and reduce the illumination of the Flash.
3. Once the foreground has been adequately illuminated, power to the Flash unit is cut off which extinguishes the flash light. The shutter remains open for the entire duration of the shutter’s speed time. The shutter then closes and the mirrors flips back down. Some camera has a Flash exposure Confirmation Led light and if the flash metering operation is successful, this light will glow.
As the OTF sensor measure the reflected light off the film, the chemical composition of the film will also affect the amount of light which will be reflected. In most cases, this will not be a problem as cameras nowadays are adjusted to operate with normal films. This only becomes a problem if you have to use specially coated films with different level of light tolerance.